[for off-road use only]
The JeepsNeeds D-Lift Adaptor is constructed out of laser cut 3/16"cold rolled steel, bent into shape as a one piece design for maximum strength and rigidity, power coated in bright yellow (among other colors), and MADE IN THE U.S.A.
DLA Patent Number: 9,850,115
The DLA currently only fits the 3/4" D-ring with 7/8"pins (standard D-ring).
Product Review and Demonstrations
Please read before purchasing the DLA regarding Hi-Lift ® jacks.
Test Result on Hi-Lift® jack accessory
There appears to be casting defects (pitched to one side) on the tongue piece of the Hi-Lift ® jacks. One side of the tongue is higher than the opposing side, preventing the DLA from correctly saddling on to the Hi-Lift ® jack, thus preventing the correct alignment of the locking pin hole.
1) Using a die grinder or a round file, enlarge the locking pin hole, on the smaller side of the tear drop shaped hole on the Hi-Lift ® jack. Trial fit as you go, do not over enlarge the smaller side of the tear drop hole. Grinding the top of the Hi-Lift ® Jack is required on some cases where the casting defect are extreme.
2) If your Hi-Lift ® jack is a new one, reach out to Hi-Lift® jack company and kindly inform them of the casting defect, they were good about sending out a new one.